58cm*3m Gold Foil Channeled Grille Wall Panel Sticker

Key Advantages

• Self-adhesive installation: Pre-applied pressure-sensitive adhesive layer; Peel and stick without drilling, gluing, or professional tools.
• Acoustic absorption: The three-dimensional grille structure increases surface area for sound wave reflection. Rated Noise Reduction Coefficient (NRC) ≥0.3 For medium to high frequencies.
• Gold foil detailing: Gold foil material embedded locally on the surface, distributed as dots or lines, creating contrast with the channeled grille pattern.
• Aging resistance: Anti-aging additives in the formulation delay surface fading and chalking caused by UV exposure and temperature variations.
• Dimensional stability: Material thickness and density design result in dimensional change rate ≤0.2%. Within temperature range of -10°C to 50°C.

Product Characteristics

Application Scenarios

• High-end residential accent walls: TV background walls, sofa back walls, entryway feature walls.
• Hotels and hostels: Lobby accent walls, guest room headboard walls, elevator lobby walls.
• Restaurants and cafes: Private dining room walls, cafe booth backgrounds, tea house decorative walls.
• Private clubs and lounges: Reception area walls, corridor decorative walls, VIP room backgrounds.
• Commercial display spaces: High-end brand showrooms, jewelry exhibition halls, art gallery walls.

Common Precautions

• Substrate requirements: Substrate must be flat, dry, free of oil, grease, loose dust, and peeling paint. For latex paint walls, verify that the paint film is firmly bonded; Loose sections must be scraped and sanded.
• Substrate flatness: Walls with height variations exceeding 1.5mm per meter require leveling to ensure full contact between channeled grille strips and the wall surface for secure adhesion and visual flatness.
• Pre-installation cleaning: Clean substrate with mild detergent to remove oil and wax. For tile walls, light sanding is recommended to increase roughness and improve adhesion.
• Application procedure: Peel off the release film, align from one edge, and press down. Use a squeegee or roller to apply even pressure, ensuring full contact between grille strip bases and the wall surface. Gold foil side faces outward; Align grille lines at seams.
• Ambient temperature: Recommended installation temperature is no lower than 10°C. At low temperatures, initial tack is reduced; Use a hair dryer to warm the adhesive layer evenly before application.
• Cutting method: Cut with a utility knife along the gaps between grille strips using a sharp blade to avoid burrs or detachment on gold foil edges. Use 45° miter cuts for corner joints. Cut with gold foil side facing up to prevent pressure-induced peeling.
• Cleaning and maintenance: Clean gently with a slightly damp soft cloth following the grille direction, avoiding excessive pressure on gold foil accent areas. Use a vacuum cleaner with a brush attachment to remove dust from grille gaps. Avoid cleaners containing solvents or abrasive particles.
• Storage conditions: Store rolls flat in a cool, dry place away from direct sunlight and high temperatures. Storage temperature should not exceed 35°C with humidity below 70%. A protective film over the gold foil surface is recommended to prevent scratching during storage.
• Removal method: Heat the surface to 50-60°C with a heat gun to soften the adhesive, then peel from corners. Residual adhesive can be removed with adhesive remover or rubbing alcohol. Partial gold foil layer detachment during removal is considered normal.