0.85*0.85cm，90g/m PVC Profile with Hot Stamped Silver Corner

Key Advantages

• Hot-stamped silver surface: Silver metallic layer applied via heat transfer, with uniform gloss
• Standard right angle: 90° angle matches standard internal and external wall corners
• Lightweight: 90g/m linear density suitable for fine edge applications
• Oxidation resistance: Surface layer shows no significant oxidation discoloration in typical indoor environments
• Moisture and corrosion resistance: PVC base does not absorb water or corrode in humid conditions

Product Features

Application Scenarios

• Internal corner trimming (recessed corners where walls meet)
• Wall-to-ceiling transition edge trimming
• External wall corner protection and decoration
• Ceiling gypsum board corner edge trimming
• Edge wrapping for accent wall patterns
• Auxiliary decorative trim for window and door frames
• Corner accent detailing for light luxury interior spaces

Common Questions and Solutions

Q1: Is the hot-stamped silver surface easily scratched during installation?
Solution: The hot-stamped layer is a surface coating. Avoid using metal scrapers or hard tools that contact the surface directly during installation. Use rubber squeegees or soft cloths for pressing. For cutting, use fine-tooth blades and orient the cut surface toward the inside of the corner, keeping the visible surface intact.

Q2: Can the product be used on non-90° corners?
Solution: The product is designed for standard 90° corners typical of perpendicular walls and ceilings. For non-standard angles (e.G., Sloped ceilings, polygonal walls), apply heat to soften the profile before adjusting the angle, or use flexible filler materials to accommodate irregular gaps.

Q3: Will the silver surface darken or lose gloss after long-term use?
Solution: The surface is treated for oxidation resistance and remains stable in typical indoor environments. Prolonged exposure to high humidity, high salt spray (e.G., Coastal buildings), or acidic conditions may cause gradual oxidation. Regular dry wiping with a soft cloth helps slow surface changes.

Q4: How to handle gaps between the corner profile and the wall after installation?
Solution: Fill gaps with color-matched anti-mold silicone sealant or acrylic filler. Clean dust from the gap before filling, apply the sealant, smooth with a squeegee, and wipe excess with a damp cloth.

Q5: Is the product suitable for rooms with underfloor heating?
Solution: PVC material remains stable at temperatures below 40°C. Wall and floor junction temperatures in underfloor heated rooms are generally below this range. Avoid direct contact between the profile and underfloor heating elements.

Installation and Usage Notes

• Clean dust, grease, and loose coatings from corner areas before installation
• Use neutral anti-mold silicone sealant or PVC-specific adhesive, applying evenly to the back of both profile legs
• Align the profile with the corner and press into place. Use a roller or squeegee to press firmly from one end to the other
• For lengthwise joints, use 45° bevel cuts to minimize visible seams
• For external corner protection, ensure the profile fully wraps the corner edge with both legs symmetrically against the walls
• Avoid touching or exposing to moisture within 24 hours after installation
• Remove excess adhesive with a damp cloth before it cures to avoid damaging the silver layer during dry removal
• For cutting, mark cut lines on the back of the profile. Lightly sand cut edges with fine sandpaper to remove burrs